HP D7171A - NetServer - LPr Manual page 19

Pci card installation and replacement and hot-plug operations

Hide thumbs Also See for D7171A - NetServer - LPr:

Chapter 6 Addendum

5. If the Power LED in the Hot-Plug Utility window stays green, then consider these steps:

a. Re-install the software driver and then repeat this procedure.

Refer to the Windows NT Help file to re-install the driver.

b. Power down the NetServer, re-seat the PCI board, power the system up, and then repeat Steps 2 to 4 in

this procedure.

c. Write down the part number and revision level of the PCI board and then contact the board's manufacturer

to determine if a new software driver is required.

6. If the green Power LED stays turned off (gray), go to the section in this chapter, "Removing a PCI Hot-Plug

Board," for the procedure to remove the PCI Hot-Plug board.

Figure 6-13. PCI Hot-Plug Utility – Power Turned Off

HP NetServer LXr 8000 Installation Guide

Table of Contents