HP D7171A - NetServer - LPr Manual page 18

Pci card installation and replacement and hot-plug operations

Hide thumbs Also See for D7171A - NetServer - LPr:

Chapter 6 Addendum

4. Confirm your selection by clicking Yes.

As soon as confirmation is complete, the Power LED (left) on the Utility screen turns off (gray) and the slot

status changes from Normal to Not Ready. The corresponding green LED on the I/O Baseboard turns off.

This means power to this slot is turned off. See Figure 6-13.

CAUTION

If the LED for the desired hot-plug slot does not turn off, do not attempt to remove the PCI Hot-

Plug board. Return to Step 1 in this procedure to ensure you have selected the correct slot to

power down.

Figure 6-12. Pop-up Menu

HP NetServer LXr 8000 Installation Guide

Table of Contents