Chapter 6 Addendum
5. At the front of the NetServer, extend the anti-tip foot out of the installation rack. See Figure 6-3.
6. Remove the bezel from the front of the NetServer.
7. Use a T-25 screwdriver to remove the screws holding the NetServer's flanges to the rack front columns.
CAUTION
To prevent damage to cables or a disruption in service due to a disconnection of cables, check for
short cables at the rear of NetServer and disconnect before proceeding.
8. Pull the NetServer out from the rack on its slides. See Figure 6-3.
Use anti-tip foot
Use handle to
pull out NetServer
Figure 6-3. Sliding Out the NetServer
HP NetServer LXr 8000 Installation Guide
Rack front columns
Flanges
7