Verify Device Support Of Commands - Digi LTS 32 User Manual

Verify device support of commands

On the configuration specific shell interface, online help is available to verify whether a
ConnectPort LTS product supports a particular command. For example:
 help displays all supported commands for a device.
 ? displays all supported commands for a device.
 set ? displays the syntax and options for the set command. Use this command to determine
whether the device includes a particular set command variant to configure various features.
 help set displays syntax and options for the set command.
 set serial ? displays the syntax and options for the set serial command.
 help set serial displays the syntax and options for the set serial command.
Here are some examples of commands used to configure the ConnectPort LTS product. See the
Introduction of the ConnectPort LTS Command Reference for a complete list of features and tasks
that can be configured and performed from the command line.
To configure:
alarms
autoconnection behaviors for serial port connections
Ethernet communications parameters
group attributes: create or establish group attributes,
update or remove groups or group attribute
host name
modem emulation
network options
network services
Point-to-Point (PPP) connections
port buffering
port profile for a serial port
Use this command:
set alarm
set autoconnect
set Ethernet
set group
set host
set pmodem
set network
set service
set ppp
set buffer
set profile
102