Alarms - Digi LTS 32 User Manual

Alarms

Use the Alarms page to configure device alarms or display current alarms settings. Device alarms
are used to send email messages or SNMP traps when certain device events occur. These events
include and certain data patterns being detected in the data stream.
Alarm notification settings
On the Alarms page, the Alarm Notification Settings control the following:
 Enable alarm notifications: Enables or disables all alarm processing for the Digi Connect
device.
Alarm conditions
The Alarm Conditions part of the Alarms page shows a list of all of the alarms. Up to 32 alarms can
be configured, and they can be enabled and disabled individually.
Alarm list
The list of alarms displays the current status of each alarm. If there are any alarms already
configured for the device, and after configuring any new alarms, this list can be used to list to view
alarm status at a glance, then view more details for each alarm as needed.
 Enable: Checkbox indicates whether the alarm is currently enabled or disabled.
 Alarm: The number of the alarm.
 Type: The basis for the alarm; whether it is based on serial data pattern matching.
 Trigger: The conditions that trigger the alarm.
 SNMP Trap: Indicates whether the alarm is sent as an SNMP trap.
If the SNMP Trap field is disabled, and the Send To field has a value, then the alarm is sent as
an email message only.
If the SNMP trap field is enabled and the Send To field is blank, then the alarm is sent as an
SNMP trap only.
If the SNMP Trap field is enabled, and a value is specified in the Send to field, then that means
the alarm is sent both as an email and as a SNMP trap.
 Send To: The email address to which the alarm is sent.
 Email Subject: The text to be included in the ―Subject:‖ line of any alarms sent as email
messages.
75