Install All Accessory Boards; Install The Netserver In The Rack - HP NetServer LH 3r Installation Road Map

7

Install All Accessory Boards

For a list of boards HP has tested, see Help topic
NOTE
"Tested Parts List" on the
CD-ROM
as described in panel 5, "Removing and
1. Remove cover 1
Replacing the Covers."
2. Read the documentation
board. Follow any special instructions and installation
recommendations. Some boards have preferred slot locations. If a
board does not, consider the boot order (see below) when
choosing the accessory board socket in which to install the board.
3. Remove the slot cover
for future use. If you are installing any full-length PCI boards, also
remove the accessory board retainer (see figure at right). Push on
the button on the retainer to release it, and then slide it out of the
board guide.
Insert each board in the desired slot and
4. Install the board:
fasten the board's mounting screw at the slot opening at the rear of
the chassis. Connect any required cables to each adapter board. If
you removed the board retainer, reinstall it.
5. Replace the cover(s):
accessories, replace the cover(s) as described in panel 5,
"Removing and Replacing the Covers."
If you install an ISA non-Plug-and-Play board,
NOTE
you must reserve system resources (some or
all of: memory addresses, I/O addresses,
IRQs, and DMA channels) for it. Note jumper
settings on the board and write down that
information for reference when you reserve
system resources in panel 12, "Configure the
HP NetServer."
Boot Device Priority
Boot order for PCI controllers is determined by slot location. The
system searches for a bootable device in the following order:
1. IDE CD-ROM drive with a bootable CD-ROM.
2. Flexible disk drive with a bootable flexible disk.
3. Embedded SCSI controller or embedded DAC.
4. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, 1.
This boot order can be changed using the SETUP utility (press [F2]
during the boot process).
8
Replace Covers and Cables
as described in panel 5, "Removing and
Replace all covers
Replacing the Covers."
9

Install the NetServer in the Rack

1. Remove the Power Supplies:
holding the two power supplies in the rear of the chassis and remove
them.
2. Install the NetServer in the Rack:
LH 3/LH 3r User Guide for instructions.
3. Reinstall the power supply modules:
HP NetServer in the rack, reinstall the power supply modules. When
the NetServer is installed in the rack, resume with panel 10 of this
road map, "Install Additional Mass Storage Devices."
All manuals and user guides at all-guides.com
HP NetServer Navigator
.
included with each accessory
for each slot to be used, and store it
If you are not installing any other
Slot 1 16-bit ISA or 32-bit PCI
Slot 2 32-bit PCI
Slot 3 32-bit PCI
Slot 4 32-bit PCI
Slot 5 32-bit PCI
Slot 6 32-bit PCI
Slot 7 32-bit PCI
Slot 8 32-bit PCI
Unscrew the thumbscrews
Refer to the HP NetServer
After installing the
Accessory Board
Retainer
Release Tab
Accessory Board
Guide
An accessory board can be identified by the offset of the bracket
and the shape of the edge connector:
Replace all covers before operating the NetServer,
CAUTION
even for a short time. Otherwise, damage to system
components may result due to improper cooling air
flow.
Do not attempt to lift this NetServer alone. Get
WARNING
assistance before installing it in the rack.
PCI Board- Left-Side Offset
ISA Board- Right-Side Offset