Replace Cover; Step F. Boot Hp Netserver Navigator To Launch Hp Netraid Assistant; Boot Hp Netserver Navigator Cd-Rom; Boot Messages - HP D5970A - NetServer - LCII Installation And Configuration Manual

Chapter 5
CAUTION Handle disk modules carefully. They are more susceptible to
shock, vibration, and electrostatic discharge when they are
not in the cabinet. When removing a module while the system
is powered on, disengage the module and wait for it to stop
spinning before removing it from its hot swap shelf.
Also, do not touch the SCSI edge connector pins. The oils on
your skin could impair the electrical connection.

Replace Cover

If you removed the power supplies, replace them according to the instructions in
your HP NetServer documentation.
Replace the cover on the computer and reconnect the HP NetServer to power and
networks.
Step F. Boot HP NetServer Navigator to Launch
HP NetRAID Assistant

Boot HP NetServer Navigator CD-ROM

To launch the HP NetRAID Assistant, you must boot from the HP NetServer
Navigator CD-ROM. The CD-ROM drive must be connected to the embedded
SCSI controller. Ensure that all the SCSI devices power up before or at the same
time as the host computer.
NOTE
HP NetRAID Series adapters do not support bootable
CD-ROM drives. The CD-ROM drive must be connected to
the embedded SCSI controller to run the HP NetServer
Navigator CD-ROM.

Boot Messages

If you receive an error message during the boot process, refer to Chapter 11,
"Troubleshooting," or to the online help in Information Assistant for more
information. Some power-up (boot) messages are routine.
52
Installation and Configuration