Other Information Sources; Tools You May Need - HP D5970A - NetServer - LCII Installation And Configuration Manual

Chapter 1
The HP NetRAID Series Installation and Configuration Guide is intended to be
used in conjunction with your HP NetServer documentation. Refer to your system
documentation for details such as cable product numbers and I/O slot boot order.
If you are setting up your HP NetServer for the first time, begin with the
HP NetServer Installation Road Map that came with your system. Return to this
guide when the roadmap instructs you to install additional I/O cards and to
configure the mass storage subsystem.

Other Information Sources

Disk array administration and management are beyond the scope of this
document. Refer to the HP NetRAID Series User Guide in Information Assistant
on the HP NetServer Navigator CD-ROM. Access it, and other material in
Information Assistant, either by booting your system from the HP NetServer
Navigator CD-ROM, or by installing Information Assistant onto any Microsoft
Windows-based PC.
You should also consult the following HP NetServer documentation:
Readme file for your HP NetServer on the HP NetServer Navigator
CD-ROM
Your HP NetServer Installation Road Map
Your HP NetServer System User Guide
Technical Reference Cards or labels on the HP NetServer system chassis
(for cables and SCSI ID switch settings)
Internet site: http://www.hp.com/go/netserver

Tools You May Need

Please refer to the HP NetServer System User Guide for the tools needed to open
the chassis. Usually a flat 1/4-inch screwdriver and a T15 TORX
required. You will also find a flashlight and a small metal pin, such as a
straightened paper clip, helpful for setting SCSI ID switches. An antistatic kit
®
(3M 8501/8502/8505 or equivalent) is strongly recommended.
10
Introduction
TM
driver is