Banyan Vines Server Installation Instructions - HP D5970A - NetServer - LCII Installation And Configuration Manual

Chapter 9
5. To the question "Install registration server?" select yes or no.
Select yes if you want this server to be the Registration Server.
Select no if this server will not be the Registration Server. Enter the
name of the Registration Server when prompted.
6. Files are copied.
7. Enter and retype the password that will be required for access to this
server. Passwords are case-sensitive.
8. Edit the regserv.dat file located at sys:\etc\regserv.dat
Replace localhost with the name of the server that will be the
Registration Server for this network.
9. Edit the hosts file located at sys:\etc\hosts. It should contain the
IP address and name of each server with HP NetRAID Series adapters to
be managed over the network.
10. Restart NetWare.
NOTE

Banyan VINES Server Installation Instructions

The installation procedure has two parts. The first step is to install HP NetRAID
Access Service on the server running Banyan VINES. The second step is to
install the HP NetRAID Assistant and HP NetRAID Registration Server utilities
on the client or server running Microsoft Windows NT (or Windows 95).
For this installation process, you need two sets of disks created by the HP
NetServer Navigator CD-ROM:
The NetRAID Utilities for Banyan VINES disks
The NetRAID Assistant for Windows NT and Windows 95 disks
106
Managing Servers Over the Network
If the NetWare server is a Registration Server, the
reg_serv.nlm will be put in autoexec.ncf to
automatically start it. However, if the software was
installed previously, but not as a Registration Server,
edit the autoexec.ncf file to add the statement
load reg_serv.nlm so that the Registration Server
will automatically start under NetWare.