Installing A Liquid Cooling Unit - HP Xw9400 - Workstation - 16 GB RAM Reference Manual

Installing a liquid cooling unit

The following steps describe installation of a liquid cooling unit.
1. Disconnect power from the system
access panel
facing up.
2. Install the liquid cooling unit rear chassis bracket if it is not already installed.
Figure 5-56
3. For a new installation, remove the plastic protectors covering the thermal interface material on the
liquid cooling unit.
Figure 5-57
4. For a reused liquid cooling unit, clean the old thermal interface material from the processor and
from the reused liquid cooling unit cold plates. Reapply new thermal interface material to the
processors and to the reused liquid cooling unit.
ENWW
(Pre-disassembly procedures on page
(Access panel on page
Install rear chassis bracket
Remove plastic protectors
63). Place the workstation on its side with the system board
Removing and replacing components 103
55), and remove the