Pci Retention Clamp - HP Xw9400 - Workstation - 16 GB RAM Reference Manual

PCI retention clamp

1. Disconnect power from the system
access panel
facing up.
2. Open the PCI retention clamp by pressing down on the two green clips at the ends of the clamp
and rotating the clamp toward the back of the system.
Figure 5-22
80 Chapter 5 Removal and replacement procedures
(Pre-disassembly procedures on page
(Access panel on page
Opening the PCI retention clamp
63). Place the workstation on its side with the system board
55), and remove the
ENWW