Removing And Replacing Components - HP Xw9400 - Workstation - 16 GB RAM Reference Manual

Removing and replacing components

This section discusses the procedures necessary to remove and install various hardware components
on your workstation.
Before servicing or upgrading your workstation:
1. Review the safety precautions and the
and Regulatory Information.
2. Locate and clear a suitable work area.
3. Shut down the system and remove power from the unit.
4. Gather your tools.
5. Remove all security devices.
6. Service your unit.
7. Restore power to your unit.
NOTE: Prior to removing and replacing a component, make sure you remove all installed components
that obstruct or prevent the removal of the component.
If you are unsure how to remove a particular component, please do one of the following:
1. Refer to the appropriate section in this chapter.
2. If the content you desire is not referenced in this chapter, see
xw9400_manuals
3. See the manufacturer's web site for instructions for a third party (non-HP) component.
58 Chapter 5 Removal and replacement procedures
and look under "Setup and Install – General" for instructions.
Service considerations on page
www.hp.com/support/
51, as well as the Safety
ENWW