HP Xw9400 - Workstation - 16 GB RAM Reference Manual page 101

To replace an optical drive:
1. Lift the green drivelock release lever while sliding the optical drive into the bay. When the optical
drive is partially inserted, release the drivelock release lever, and slide the drive completely into
the bay until the drive is secured.
CAUTION:
when moving the workstation.
2. Connect the power, data , and audio (if required) cables to the drive and workstation.
NOTE:
3. If you are installing more than one optical drive, route the cable as in the following image.
Figure 5-37
ENWW
Ensure that the optical drive is secure. Failure to do so can cause damage to the drive
The audio cable is only required for Linux-based systems.
Connecting IDE (left) or SATA (right) optical drive cable to system board
Removing and replacing components 91