Optical Drive - HP Xw9400 - Workstation - 16 GB RAM Reference Manual

Optical drive

Your workstation might have a SATA or an IDE optical drive. To remove the optical drive:
1. Disconnect power from the system
access panel
2. Disconnect the audio (1), data (2), and power (3) cables from the drive. The connector colors might
be different than illustrated.
NOTE:
Figure 5-35
3. Lift the green drivelock release lever, and gently slide the drive out of the chassis.
Figure 5-36
90 Chapter 5 Removal and replacement procedures
(Access panel on page
The audio cable is only required for Linux-based systems.
Disconnecting IDE (left) or SATA (right) cable from optical drive
Removing optical drive from chassis
(Pre-disassembly procedures on page
63).
55) and remove the
ENWW