Removing Memory Module - HP Xw9400 - Workstation - 16 GB RAM Reference Manual

Removing memory module

1. Disconnect power from the system
access panel
facing up.
CAUTION:
power off the workstation and unplug the power cord from the AC power outlet. Wait until the LED
on the back of the power supply turns off before removing memory. If you do not unplug the power
cord while installing memory, your memory modules might be damaged and the system will not
recognize the memory changes.
2. Remove the memory fan. Press the tab in on the memory fan housing (1) and lift the unit out of the
chassis (2).
NOTE:
rear slots.
Figure 5-15
3. Gently push out on the socket levers (1).
ENWW
(Access panel on page
To ensure that memory modules are not damaged during removal or installation,
The system fan (System fan on page 70
Removing memory fan
(Pre-disassembly procedures on page
63). Place the workstation on its side with the system board
) must also be removed to access DIMMs in the
Removing and replacing components
55), and remove the
73