System Fan - HP Xw9400 - Workstation - 16 GB RAM Reference Manual

System fan

To remove the system fan:
1. Disconnect power from the system
access panel
facing up.
2. Disconnect the fan power plug from the system board (1).
3. Press down on the ribbed portion of the system fan housing (2), rotate the fan housing down, and
lift the unit out of the chassis.
Figure 5-13
To replace the system fan, reverse the previous steps.
CAUTION:
is going out of the chassis to avoid overheating.
70 Chapter 5 Removal and replacement procedures
(Access panel on page
Removing the system fan
When installing the system fan, be sure that the fan is situated so that the airflow direction
(Pre-disassembly procedures on page
63). Place the workstation on its side with the system board
55), and remove the
ENWW