Hard drive
Replacing a hard drive
For more information on SATA hard drives and the SATA RAID configuration, see
devices on page
Removing a hard drive
1.
Disconnect power from the system
access panel
2.
Disconnect the cables from the hard drive.
3.
Push in on the green drivelock release tabs, and pull the hard drive out of the chassis.
Figure 5-42
ENWW
172.
(Access panel on page
Removing the hard drive
(Pre-disassembly procedures on page
63).
Removing and replacing components
Appendix B—SATA
55), and remove the
95