Appendix E Appendix E- Power Cord Set Requirements - HP Xw9400 - Workstation - 16 GB RAM Reference Manual

E Appendix E— Power cord set
requirements
The power cord set (flexible cord or wall plug) received with this product meets the requirements for use
in the country where you purchased the equipment.
If you must obtain a power cord for a different country, purchase a power cord that is approved for use
in that country.
The power cord must be rated for the product and for the voltage and current marked on the product's
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and
current rating marked on the product. The length of the cord must be between 1.8m (6 feet) and 3.6m
(12 feet). If you have questions about the type of power cord to use, contact an HP authorized service
provider.
Route the power cord so that it is not likely to be walked on or pinched by items placed on it or against
it. Pay particular attention to the plug, electrical outlet, and the point where the cord exits from the
product.
NOTE: Use a 15 A-capable (minimum) power cord with a 110V power source. Use a 10 A-capable
(minimum) power cord with a 220V power source.
186 Appendix E Appendix E— Power cord set requirements ENWW