Pci Or Pci Express Installation - HP Xw9400 - Workstation - 16 GB RAM Reference Manual

PCI or PCI Express installation

1. Disconnect power from the system
access panel
facing up, and remove the PCI retainer
2. Open the PCI retention clamp by pressing down on the two green clips (1) at the ends of the clamp
and rotating the clamp toward the back of the system.
3. Remove the PCI slot cover (2).
4. Lower the PCI (3) or PCI Express (3) card into the chassis. Verify that the keyed components of
the card align with the socket.
If installing a card with an auxiliary power connector, plug in the power supply cable or adapter
cable supplied with the card (4).
5. Ensure that all cards are properly seated, and close the PCI retention clamp.
Figure 5-25
ENWW
(Access panel on page
Installing PCI or PCIe card
(Pre-disassembly procedures on page
63). Place the workstation on its side with the system board
(PCI retention clamp on page
Removing and replacing components
55), and remove the
80).
83