Using Scsiselect With Scsi Devices - HP Xw9300 - Workstation - 1 GB RAM Technical Reference Manual

Using SCSISelect with SCSI Devices

The Ultra160 and faster SCSI host adapters include the SCSISelect utility to configure the host adapter and
to run the SCSI disk utilities. To run the SCSISelect utility:
NOTE: The onboard LSI SCSI controller on the xw9300 has an "LSI Logic Configuration Utility" that you
access through Ctrl-C when the LSI option ROM is initializing.
In POST Messages Enabled mode: Press Ctrl+A when the "Press<Ctrl><A> for SCSISelect Utility"
•
message appears during POST. The utility will only be present if an Adaptec SCSI card is present.
• In POST Messages Disabled mode: When the HP logo screen appears, press any key to exit the logo
screen. Immediately after exiting the logo screen, press Ctrl+A to access the SCSISelect utility. The
utility will only be present if an Adaptec SCSI card is present.
A menu appears with the following options:
• Configure/View Host Adapter Settings
• SCSI Bus Interface Definitions
• Host Adapter SCSI ID
• SCSI Parity Checking
• Host Adapter SCSI Termination
• Additional Options
• Boot Device Options
• SCSI Device Configuration
• Advanced Configuration Options
• SCSI Disk Utilities
• Lists all SCSI devices and SCSI ID numbers
NOTE: For additional information about configuring POST message display status, refer to
Setup Menu" on page 47.
"Computer
Using SCSISelect with SCSI Devices 173