Using SCSISelect with SCSI Devices
✎
Hardware Reference Guide
The SCSI host adapter includes the SCSISelect utility to configure
the host adapter and to run SCSI disk utilities. To run the SCSISelect
utility:
■
In Post Messages Enabled mode: Press
Press <Ctrl><A> for SCSISelect Utility message displays
during POST.
■
In Post Messages Disabled mode: When the HP logo screen
displays, press any key to exit the logo screen. Immediately
after exiting the logo screen, press
SCSISelect utility.
A menu displays with the following options:
■
Configure/View Host Adapter Settings
❏
SCSI Bus Interface Definitions
◆
Host Adapter SCSI ID
◆
SCSI Parity Checking
◆
Host Adapter SCSI Termination
❏
Additional Options
◆
Boot Device Options
◆
SCSI Device Configuration
◆
Advanced Configuration Options
■
SCSI Disk Utilities
❏
Lists all SCSI devices and SCSI ID numbers
For additional information about configuring POST message display
status, refer to the Computer Setup Guide on the Documentation
Library CD.
Hard Drive Installation
Ctrl + A
when the
Ctrl + A
to access the
B–7