Using Computer Setup (F10) - HP Xw9300 - Workstation - 1 GB RAM Technical Reference Manual

Using Computer Setup (F10)

You can only open Computer Setup by turning on the workstation or restarting the system. To access the
Computer Setup Utilities menu:
1. Turn on or restart the workstation.
Press the F10 key as soon as the monitor light turns green.
2.
f you do not press the F10 key at the appropriate time, you must restart the workstation and press
NOTE:
and hold the F10 key again to access the utility.
3. Select your language from the list and press Enter. In the Computer Setup Utilities menu, four
headings are displayed: File, Storage, Security, and Advanced.
4. Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down)
keys to select the option you want, then press Enter.
To apply and save changes, select File > Save Changes and Exit.
5.
• If you have made changes that you do not want applied, select Ignore Changes and Exit.
• To reset to factory settings, select Set Defaults and Exit. This option restores the original factory
system defaults.
CAUTION: Do NOT turn the workstation power OFF while the ROM is saving your Computer Setup F10
changes because the CMOS could become corrupted. After you exit the F10 Setup screen, it is safe to turn
off all power to the workstation.
46 System Management