Power On Self Test (Post) And Error Messages - HP Xw9300 - Workstation - 1 GB RAM Technical Reference Manual

Hp xw9300 service and technical reference guide
Hide thumbs Also See for Xw9300 - Workstation - 1 GB RAM:
Table of Contents

Advertisement

Power On Self Test (POST) and Error Messages

POST is a series of diagnostic tests that runs automatically when the system is turned on. An audible,
visual, or both message occurs if the POST encounters a problem. POST checks the following items to
ensure that the workstation system is functioning properly:
Keyboard
Memory modules
Diskette drives
All SATA and SCSI mass storage devices
Processors
Controllers
NOTE:
If the Power-On Password is set, a key icon appears on the screen while POST is running. You
must enter the password before continuing.
Table 5-38
POST Error Messages
Screen Message
101—Option ROM Error
102—System Board Failure DMA, timers, etc.
110—Out of Memory for
Option ROMs
162—System Options Not
Set
163—Time and Date
Not Set
Probable Cause
System ROM checksum.
Option ROM for a device was
unable to run due to memory
constraints.
Configuration incorrect. RTC battery
might need to be replaced.
Invalid time or date in configuration
memory.
RTC (real-time clock) battery might
need to be replaced.
CMOS jumper might not be
properly installed.
Recommended Action
Verify the correct ROM.
1.
Flash the ROM, if needed.
2.
If an expansion card was recently added,
remove it and see if the problem remains.
3.
Clear CMOS.
4.
If the message disappears, there might be
a problem with the expansion card.
5.
Replace the system board.
1.
Clear CMOS.
2.
Remove expansion boards.
3.
Replace the system board.
Run Computer Setup and disable unneeded
devices from Advanced > Onboard
Devices. Or, disable option ROMs from
Advanced > Device Options.
1.
Run Computer Setup (F10 Setup).
2.
Set the date and time under Control Panel or
in F10 Setup depending on the operating
system.
3.
If the problem persists, replace the RTC
battery.
1.
Set the date and time under Control Panel or
in F10 Setup depending on the operating
system.
2.
If the problem persists, replace the RTC
battery.
Power On Self Test (POST) and Error Messages 165

Advertisement

Table of Contents
loading

Table of Contents