Installing An External Scsi Hard Drive - HP Xw9300 - Workstation - 1 GB RAM Technical Reference Manual

Installing an External SCSI Hard Drive

You can add an external SCSI connector to the on-board SCSI controller.
To install the external connector:
1. Disconnect power from the system
card support
2. Disconnect the optical drive cable and the diskette drive cable, if installed, from the system board.
3. Plug the data cable into the external SCSI port on the system board and route the cable under the PCI
card guide as shown in the following illustration.
4. Reconnect the optical drive cable and the diskette drive cable, if installed, to the system board.
5. Lift the PCI levers
6. Remove the PCI slot cover
7. Lower the other end of the data cable
8. Close the PCI levers
114 Removal and Replacement Procedures
(page
(page 98), if installed.
1 by first pressing down and then up.
2 from closest to the system fan.
4
. If the PCI levers do not close, be sure all cards are properly seated.
79), remove the access panel
3 into the chassis.
(page 86), and remove the PCI