System Board Architecture; Removal And Replacement Of Components; Disassembly Order - HP Xw6400 - Workstation - 4 GB RAM Reference Manual

System board architecture

The following image shows the HP xw6400 Workstation block diagram.
Figure 4-2

Removal and replacement of components

This section discusses the procedures necessary to remove and install various hardware components
on your workstation. Review the safety and precautions and the
well as the Safety and Regulatory Information, before servicing or upgrading your system.
1. Read all safety information and precautions.
2. Locate and clear a suitable work area.
3. Shut down the system and remove power from the unit.
4. Gather your tools.
5. Service your unit.
6. Restore power to your unit.

Disassembly order

Use the following table to determine the sequence in which to remove the major components.
Predisassembly
(Predisassembly
procedures on page
ENWW
System board block diagram
57)
Service considerations on page

Removal and replacement of components

52, as
59