HP Xw6400 - Workstation - 4 GB RAM Reference Manual page 80

To remove the memory fan:
1. Disconnect power from the system
access panel
2. Disconnect the memory fan cable from its connector on the system board 1.
3. Grasp the two green touch point tabs 2, lift up and away 3 from the system fan housing.
Figure 4-14
To replace the memory fan:
1. Align the two center and two outer hooks to the circular opening of the system fan housing.
2. Press down on the memory fan housing until it snaps into position 1.
Figure 4-15
3. Connect the memory fan cable to its connector on the system board 2.
70 Chapter 4 Removal and replacement procedures
(Predisassembly procedures on page
(Side access panel on page
Removing the memory fan
Replacing the memory fan
63).
57) and remove the side
ENWW