Pci Express Installation - HP Xw6400 - Workstation - 4 GB RAM Reference Manual

4. Lower the PCI 3 card into the chassis. Verify that the keyed components of the card align with the
socket.
5. Close the PCI retention clamp 4 by rotating the clamp downward and pushing on the two green
snaps down from the rear panel of the chassis.
Figure 4-27

PCI Express installation

1. Disconnect power from the system
access panel
2. Release the PCI retention clamp by first pressing down on the green snaps 1 and rotating the clamp
upward.
3. Remove the PCI slot cover 2.
4. Lower the PCI Express 3 card into the chassis. Verify that the keyed components of the card align
with the socket.
80 Chapter 4 Removal and replacement procedures
Installing the PCI card
(Side access panel on page
(Predisassembly procedures on page
63).
57) and remove the side
ENWW