Download  Print this page

Processor; Removing The Processor - HP Xw6400 - Workstation - 4 GB RAM Reference Manual

Hp xw6400 workstation - service and technical reference guide.
Hide thumbs

Advertisement

6.
Connect the CPU heatsink fan connector to the system board 1.
Figure 4-48

Processor

Removing the processor

1.
Disconnect power from the system
access panel
heatsink on page
2.
Lift the processor cover 1 off the assembly. Raise the processor socket handle fully 2 (the full swing
angle of the lever is approximately 135 degrees). Lift the processor retainer 3 away from the
processor.
Figure 4-49
94
Chapter 4 Removal and replacement procedures
Connect CPU heatsink fan cable to system board
(Predisassembly procedures on page
(Side access panel on page
91).
Raising the processor socket handle
63) and the CPU heatsink
57). Remove the side
(Removing the CPU
ENWW

Advertisement

Table of Contents

   Also See for HP Xw6400 - Workstation - 4 GB RAM

   Related Manuals for HP Xw6400 - Workstation - 4 GB RAM

Comments to this Manuals

Symbols: 0
Latest comments: