HP Xw6400 - Workstation - 4 GB RAM Reference Manual page 95

3. Lift the green drive-lock release lever 1 and gently slide the drive 2 out of the chassis.
Figure 4-34
To :
1. Lift the green drive-lock release lever while sliding the optical drive into the bay. When the optical
drive is partially inserted, release the drive-lock release lever and slide the drive inward until the
drive snaps into place, securing the drive.
CAUTION:
when moving the workstation.
2. Connect the power, data, and audio (if required) cables to the drive and workstation.
NOTE:
3. If you are installing more than one optical drive, route the cable as in the following image.
NOTE:
Figure 4-35
ENWW
Removing the optical drive from the chassis
Ensure that the optical drive is secure. Failure to do so can cause damage to the drive
The audio cable is only required for Linux-based systems.
The optical drive cable is routed under the system board.
Connecting the optical drive cable to the system board
Removal and replacement of components 85