HP Xw6400 - Workstation - 4 GB RAM Reference Manual page 97

3. While lifting the green drive-lock release lever 1, slide the drive forward 2 out of the chassis.
Figure 4-37
To replace an optional diskette drive:
1. Lift the green drive-lock release lever while sliding the diskette drive into the bay. When the diskette
drive is partially inserted, release the drive-lock release lever and slide the drive inward until the
drive snaps into place, securing the drive.
2. Route the diskette drive data cable between the system board and the hard drive cage. Your cable
might look different than the one shown.
CAUTION:
necessary to push the cable down so that it catches on the system board. This routing method is
important because you do not want to interfere with the CPU heatsink fans or block airflow.
Figure 4-38
3. Connect the cables to the back of the diskette drive.
ENWW
Removing the diskette drive from the chassis
The cable must stay between the system board and the hard drive cage. It might be
Routing the diskette drive cable to the system board
Removal and replacement of components 87