Converter Board - HP Pro 4300 Maintenance And Service Manual

Converter Board

The converter board is located on the left side of the computer (viewed from behind) under the main
rear cover. It is secured with two Torx screws and has two connectors.
Figure 6-46
To remove the converter board:
1. Prepare the computer for disassembly (see
on page
2. Remove the center access panel (see
3. Remove the memory access panel (see
4. Remove the drive access panel (see
5. Remove the stand (see
6. Remove the optical drive (see
7. Remove the top panel (see
8. Remove the rear cover (see
9. Disconnect the two cables from the board (1).
NOTE:
pull on the wires.
10. Remove the two silver Torx screws (2) that secure the board to the computer.
58 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
Converter board location
26).
Stand on page
Optical Drive on page
Top Panel on page
Rear Cover on page
Be careful not to damage the cables when disconnecting them from the board. Do not
Preparing to Disassemble the Computer
Hinge Cover Panel on page
Memory Access Panel on page
Drive Access Panel on page
54).
33).
51).
55).
27).
29).
31).