Power Switch Assembly - HP Pro 4300 Maintenance And Service Manual

Power Switch Assembly

The power switch assembly is located on the bottom corner of the inside of the front bezel. You must
remove the front bezel from the computer to remove the power switch assembly from the bezel.
Figure 6-72
To remove the power switch assembly:
1. Prepare the computer for disassembly (see
on page
2. Remove the center access panel (see
3. Remove the memory access panel (see
4. Remove the drive access panel (see
5. Remove the stand (see
6. Remove the optical drive (see
7. Remove the top panel (see
8. Remove the rear cover (see
9. Remove the front bezel (see
10. Pull the two tabs (1) toward the bottom of the bezel, and then rotate the assembly up and off the
bezel (2).
11. Pull the light pipe out of its slot (3).
82 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
Power switch assembly location
26).
Stand on page
Optical Drive on page
Top Panel on page
Rear Cover on page
Front Bezel on page
Preparing to Disassemble the Computer
Hinge Cover Panel on page
Memory Access Panel on page
Drive Access Panel on page
54).
33).
51).
55).
77.
27).
29).
31).