HP Pro 4300 Maintenance And Service Manual page 87

6. Remove the top panel (see
7. Remove the rear cover (see
8. Remove the power switch assembly from the front bezel (see
on page 82).
NOTE: After you remove the power switch assembly with LED and cable from the front bezel,
you do not have to remove the side key cable.
9. Remove the front bezel (see
10. Disconnect the display cable from the display panel (1).
NOTE: Replace the backlight cable (2) with the new backlight cable that comes with the new
display panel kit.
Remove the backlight cable from the defective panel before sending the panel back to the
supplier.
Figure 6-69 Removing the display cable from the display panel
Top Panel on page 51).
Rear Cover on page 55).
Front Bezel on page 77).
Power Switch Assembly
Display Panel 79