Speakers - HP Pro 4300 Maintenance And Service Manual

Speakers

The speakers are located at the bottom of the computer. Two separate speakers are each secured by
two Torx screws and have separate cables and system board connectors.
Figure 6-57
To remove the speakers:
1. Prepare the computer for disassembly (see
on page
2. Remove the center access panel (see
3. Remove the memory access panel (see
4. Remove the drive access panel (see
5. Remove the stand (see
6. Remove the optical drive (see
7. Remove the heat sink cover (see
8. Remove the top panel (see
9. Remove the rear cover (see
10. Remove the system board shield (see
11. Remove two Torx screws that secure each speaker to the computer.
12. Disconnect the speaker cables from the system board connectors . The left speaker connects to
the white connector labeled LFT_SPKR. The right speaker connects to the black connector
labeled RT_SPKR.
66 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
Speaker location
26).
Stand on page
Optical Drive on page
Top Panel on page
Rear Cover on page
Preparing to Disassemble the Computer
Hinge Cover Panel on page
Memory Access Panel on page
Drive Access Panel on page
54).
33).
Heat Sink Cover on page
51).
55).
System Board Shield on page
27).
29).
31).
45).
62).