Stand
The stand is secured with three Torx screws. You must remove the center access panel to remove
the stand.
To remove the stand:
1.
Prepare the computer for disassembly (see
on page
2.
Remove the center access panel (see
3.
Remove the three silver Torx screws (1) that secure the stand to the computer.
4.
Lift the memory and drive access panel latches (2).
5.
Slide the stand toward the top of the computer slightly (3), and then lift the stand off the
computer (4).
Figure 6-41
To replace the stand, reverse the removal procedures.
54
Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
26).
Removing the stand
Preparing to Disassemble the Computer
Hinge Cover Panel on page
27).