Rear Cover - HP Pro 4300 Maintenance And Service Manual

Rear Cover

The rear cover is secured with four Torx screws. The optical drive security screw also secures the
rear cover. After removing the screws, you must pry it off at the seams around the edges of the
computer.
To remove the rear cover:
1. Prepare the computer for disassembly (see
on page
2. Remove the center access panel (see
3. Remove the memory access panel (see
4. Remove the drive access panel (see
5. Remove the stand (see
6. Remove the optical drive (see
7. Remove the top panel (see
8. Remove the five black Torx screws that secure the rear panel to the computer (1).
9. Pry the cover off the computer by pulling the top edge (2) loose, then prying the side loose near
the memory modules (3), bottom side (4), and left side (5).
NOTE:
Figure 6-42
10. Remove the rear cover from the computer.
To replace the rear cover, reverse the removal procedures.
26).
Stand on page
Optical Drive on page
Top Panel on page
The cover may be very tight and difficult to remove.
Removing the rear cover
Preparing to Disassemble the Computer
Hinge Cover Panel on page
Memory Access Panel on page
Drive Access Panel on page
54).
33).
51).
27).
29).
31).
Rear Cover 55