Stand Bracket - HP Pro 4300 Maintenance And Service Manual

Stand bracket

The stand bracket is located near the middle of the computer, below the fan. Remove the bracket to
gain access to the drive cables and sidekey board cable assembly. The bracket is secured with four
Torx screws.
Figure 6-59
To remove the stand bracket:
1. Prepare the computer for disassembly (see
on page
2. Remove the center access panel (see
3. Remove the memory access panel (see
4. Remove the drive access panel (see
5. Remove the stand (see
6. Remove the optical drive (see
7. Remove the top panel (see
8. Remove the rear cover (see
68 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
Stand bracket location
26).
Stand on page
Optical Drive on page
Top Panel on page
Rear Cover on page
Preparing to Disassemble the Computer
Hinge Cover Panel on page
Memory Access Panel on page
Drive Access Panel on page
54).
33).
51).
55).
27).
29).
31).