Display Cable - HP Pro 4300 Maintenance And Service Manual

Display Cable

The main display cable connector is located behind the system board. You must remove the system
board to remove the display cable.
Figure 6-66
To remove the display cable:
1. Prepare the computer for disassembly (see
on page
2. Remove the center access panel (see
3. Remove the memory access panel (see
4. Remove the drive access panel (see
5. Remove the stand (see
6. Remove the optical drive (see
7. Remove the heat sink cover (see
8. Remove the heat sink (see
9. Remove the top panel (see
10. Remove the rear cover (see
11. Remove the system board shield (see
12. Remove the system board (see
Display cable location
26).
Stand on page
Optical Drive on page
Heat Sink (Thermal Module) on page
Top Panel on page
Rear Cover on page
Preparing to Disassemble the Computer
Hinge Cover Panel on page
Memory Access Panel on page
Drive Access Panel on page
54).
33).
Heat Sink Cover on page
51).
55).
System Board Shield on page
System Board on page
27).
29).
31).
45).
47.
62).
70).
Display Cable 75