Power Menu; Boot Menu; Exit Menu - IBM NetVista Hardware Maintenance Manual

Password on Boot
This parameter will enable or disable check password
when booting the system. The default is Disabled.

Power Menu

There is only one parameter in this menu. The
parameter disable or enable power savings. Default
is Disabled.

Boot Menu

This menu shows information regarding system boot.

Exit Menu

If you want to setup exit procedures, choose Exit
Menu. There are Exit Saving Changes, Exit
Discarding Changes, Load Setup Defaults, Discard
Changes, and Save Changes.
Exit Saving Changes
After changing any parameter in the Setup
Configuration setting, return to Configuration/Setup
Utility Exit Menu and select Exit Saving Changes to
save all the settings you have changed. Click Yes, to
save the configuration changes and exit.
Exit Discarding Changes
Press Esc to return to the Main Menu when you have
finished viewing settings and making changes. Then,
Select Exit Menu, from this location, you can choose
Exit Discarding Changes to exit Setup but without
saving your changes.
Load Setup Defaults
The computer is already configured for use. The
original configuration settings, also called factory or
default settings, are stored in the CMOS. Setup
includes an option Load Setup Defaults that lets you
reload the original configuration at any time.
To load the default settings, follow these steps:
1. Use down-arrow key to select Load Setup Defaults
in Exit Menu. A dialog box appears confirming if
you want to load the default settings.
2. Use the left-arrow key to select Yes, then press
Enter.
3. Press Esc to exit Setup.
General Information 21