IBM NetVista Hardware Maintenance Manual page 51

Local Bus IDE Adapter
The available options are Both, Disabled, Primary
and Secondary. The default is Both.
Serial Port A
The available options are Auto, Disabled and
Enabled. The default is Auto.
Parallel Port
The available options are Enabled, Auto and
Disabled. The default is Enabled.
Base I/O Address
The available options are 378, 278, and 3BC. The
default is 378.
Interrupt
The available options are IRQ7 and IRQ 5. The
default is IRQ7.
Mode
The available options are ECP, Output Only, Bi-
directional and EPP. The default is ECP.
DMA Channel
The available options are DMA3 and DMA1. The
default is DMA3.
Floppy Disk Controller
The available options are Enabled, Disabled and
Auto. The default is Enabled.
Base I/O Address
The available options are Primary and Secondary.
The default is Primary.
Audio
The available options are Enabled and Disabled. The
default is Enabled.
PCI Device, Slot #1/Slot #2/Slot #3
This sub-menu shows information of Option ROM
Scan, Enable Master, and latency Timer.
General Information 19