System Power Control Menu - IBM RS/6000 User Manual

Use the system reset string option to enter the system reset string, which resets the
machine when it is detected on the main console on Serial Port 1.
Use the Snoop Serial Port option to select the Serial Port to Snoop.
Note: Only Serial Port 1 is supported.
After Serial Port Snooping is correctly configured, at any point after the system unit is
booted to AIX, whenever the reset string is typed on the main console, the system unit
uses the Service Processor reboot policy to restart. This action causes an EPOW (Early
Power Off Warning) to be logged, and also an AIX dump to be created if the machine is
at an AIX prompt, with AIX in such a state that it can respond. If AIX cannot respond,
the EPOW record is created, rather than the AIX dump.
Pressing Enter after the reset string is not required, so make sure that the string is not
common or trivial. A mixed-case string is recommended.

System Power Control Menu

The menu is used to set power control options.
1. Enable/Disable Unattended Start Mode:
2. Ring Indicate Power-On Menu
3. Reboot/Restart Policy Setup Menu
4. Power-On System
5. Power-Off System
6. Enable/Disable Fast System Boot:
7. Boot Mode Menu
98. Return to Previous Menu
99. Exit from Menus
1>
Enable/Disable Unattended Start Mode
Use this option to instruct the service processor to immediately power-on the server
after a power failure, bypassing power-on password verification. Unattended Start Mode
can also be set using SMS menus. Unattended Start Mode can be used on servers that
require automatic power-on after a power failure.
Boot Mode Menu
Allows users to configure the system to automatically start a specific function on the
next system start. This configuration applies to the next boot only and is reset to the
default state of being disabled following a successful boot attempt.
48
User's Guide
SYSTEM POWER CONTROL MENU
Currently Disabled
Currently Disabled