IBM NetVista Hardware Maintenance Manual page 71

Error Symptoms
Incorrect memory size
shown or repeated during
POST.
System works but fails to
enter power saving mode
when the Power
Management Mode is set to
[Enabled], and power
saving timer set in BIOS has
elapsed.
System hangs before
system boot.
System hangs after system
boot.
Blinking cursor only; system
does not work.
Action/FRU
1. Insert the memory
modules in the RIMM
sockets properly, then
reboot the system.
2. Memory module. See
"005 -" on page 59 to
replace memory
module.
3. System board.
1. Enter Configuration/
Setup Utility and load
default settings.
2. In Windows ME or
Windows 2K, check
settings in Power
Management Property
of Control Panel.
3. Reload software from
Recovery CD.
1. See "Index of
Symptoms, Messages,
Error Codes, or Beeps"
on page 32.
2. See "Undetermined
Problems" on page 68
1. Execute a system test
("Diagnostics / All
Tests" in PC-Doctor
diagnostics program)
and set it to stop at
"Halt on Error" to see
the potential cause of
the problem.
2. "Undetermined
Problems" on page 68.
1. See "Start" on page 27.
2. Diskette/IDE drive
connection/cables
3. Diskette/IDE disk
drives
4. See "Undetermined
Problems" on page 68
5. System board
Check Procedures 39