Notices; Voltage Supply Switch Settings - IBM NetVista Hardware Maintenance Manual

Notices

References in this publication to IBM products,
programs, or services do not imply that IBM intends
to make these available in all countries in which IBM
operates. Any reference to an IBM product, program,
or service is not intended to state or imply that only
IBM's product, program, or service may be used. Any
functionally equivalent product, program, or service
that does not infringe any of IBM's intellectual
property rights, or other legally protectable rights,
may be used instead of the IBM product, program, or
service. References in this publication to IBM
products, programs, or services are purely hardware-
related and do not cover circumstances of software
problems. Evaluation and verification of operation in
conjunction with other products, program, or services,
except those expressly designated by IBM are the
user's responsibility.
IBM may have patents or pending patent applications
covering subject matter in this document. The
featuring of these patents, pending or otherwise, in
this document does not give you any license to these
patents. You can send license inquires, in writing, to
the IBM director of Commercial Relations, IBM
Corporation, Purchase, NY10577.

Voltage Supply Switch Settings

Your IBM Personal Computer might have voltage
switches, which must be set correctly for your voltage
supply. If your monitor or system unit has a voltage
switch, complete these steps to make sure each
switch is set correctly:
1. Determine the correct voltage switch setting for
your area:
Voltage Supply Range
100-127 V
200-240 V
2. Locate the voltage switch on the back of your
monitor or system unit. If the setting shown on the
switch is:
•
Correct: start setting up your IBM computer.
•
Incorrect: change the voltage switch setting.
Voltage Switch Setting
115 V
230 V
Notices vii