Cabletron Systems 9A426-01 User Manual page 27

Switch
8
7
6
5
4
3
2
1
1
Do not toggle Switch 8 unless you intend to reset the user configured passwords
to their factory default settings.
!
2
CAUTION
Do not toggle Switch 7 unless you intend to reset the user parameters to the
factory default settings.
Preparing and Installing the 9A426-01 Module
Table 2-1. Function of DIP Switch
Function
When toggled, this switch clears user-entered
passwords stored in NVRAM, and restores the
Clear
default passwords. Once the passwords are
1
Password
reset, you can use the defaults or enter new
passwords.
The module uses NVRAM to store user
entered parameters such as IP addresses,
device name, etc. To reset these parameters to
Clear the factory defaults, toggle this switch. Once
2
NVRAM reset you can use the defaults or enter new
parameters that are stored in NVRAM when
the module is powered down, and remain
there until the switch is toggled again.
Toggling this switch after pulling the board out
SmartSwitch 9000
of the
information from NVRAM and forces image
Force BootP
files to be downloaded from the station
Download
connected to the EPIM on the Environmental
Module configured to act as that module's
B P server.
OOT
For Factory Use Only
Reserved
For Factory Use Only
Reserved
For Factory Use Only
Reserved
For Factory Use Only
Reserved
For Factory Use Only
Reserved
Description
, clears download
2-11