Resetting The Control Timers - Cisco SPA112 Administration Manual

Configuring Voice
Configuring Dial Plans
NOTE
STEP 1
STEP 2
STEP 3
Cisco SPA100 Series Phone Adapters Administration Guide
SYNTAX 2: sequence Ss
Use this syntax to apply the new setting to a particular dialing sequence.
s: The number of seconds; if no number is entered after S, the default timer of 5
seconds applies.
Examples for the Interdigit Short Timer
Set the timer for the entire dial plan.
S:6,(9,8<:1408>[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxx | 9,8,011xx. | 9,8,xx.| [ 1-8]xx)
S:6, While entering a number with the phone off hook, a user can pause for up to
15 seconds between digits before the Interdigit Short Timer expires.
Set an instant timer for a particular sequence within the dial plan.
(9,8<:1408>[2-9]xxxxxx | 9,8,1[2-9]xxxxxxxxxS0 | 9,8,011xx. | 9,8,xx.|[1-8]xx)
9,8,1[2-9]xxxxxxxxxS0 With the timer set to 0, the call is transmitted
automatically when the user dials the final digit in the sequence.

Resetting the Control Timers

You can use the following procedure to reset the default timer settings for all calls.
To edit a timer setting only for a particular digit sequence or type of call, you can
edit the dial plan. See
Log in to the configuration utility. If prompted, enter the administrative logon
provided by the Service Provider. The default username and password are both
admin.
Under the Voice menu, click Regional.
In the Control Timer Values section, enter the desired values in the Interdigit Long
Timer field and the Interdigit Short Timer field. See the definitions at the
beginning of this section.
Digit Sequences, page 43.
4
51