Log Module - Cisco SPA112 Administration Manual

Administration Settings
Logging
NOTE
NOTE
Cisco SPA100 Series Phone Adapters Administration Guide

Log Module

Use the Administration > Log > Log Module page to enable and configure
logging.
As a best practice, Cisco recommends that you enable logging only when needed,
and disable logging when you finish the investigation. Logging consumes
resources and can impact system performance.
To open this page: Click Administration in the menu bar, and then click Log > Log
Module in the navigation tree.
If you want to enable email or syslog server logging, first specify the email or syslog
server settings on the Log Setting page.
Enter the settings as described below. After making changes, click Submit to save
your settings, or click Cancel to abandon any unsaved entries.
Field
Status
Log - Enable
Service
Description
Click Enabled to enable logging, or click Disabled to
disable logging. The default setting is Disabled.
Check the box in the heading row to enable logging for
all services (kernel and system). Alternatively, check the
box for kernel or system to enable logging for that
service.
The type of service to include: kernel or system.
5
124