Cisco SPA112 Administration Manual page 80

Configuring Voice
Configuring Voice Settings
Cisco SPA100 Series Phone Adapters Administration Guide
- Ring Frequency: 25
- Ring Voltage: 80Vc
Field
Ring Waveform
Ring Frequency
Ring Voltage
CWT Frequency
Synchronized
Ring
Control Timer Values (sec)
Field
Hook Flash Timer
Min
Hook Flash Timer
Max
Callee On Hook
Delay
Reorder Delay
Call Back Expires
Description
Waveform for the ringing signal. Choices are Sinusoid or
Trapezoid. Default setting: Sinusoid.
Frequency of the ringing signal. Valid values are 10–100 (Hz)
Default setting: 20.
Ringing voltage. Choices are 60–90 (V) Default setting: 85.
Frequency script of the call waiting tone. All distinctive
CWTs are based on this tone. Default setting: 440@-10.
If this is set to Yes, when the ATA is called, all lines ring at the
same time (similar to a regular PSTN line) After one line
answers, the others stop ringing. Default setting: no.
Description
Minimum on-hook time before off-hook qualifies as
hookflash. Less than this the on-hook event is ignored.
Range: 0. 1 –0.4 seconds. Default setting: 0. 1 .
Maximum on-hook time before off-hook qualifies as
hookflash. More than this the on-hook event is treated as
onhook (no hook-flash event) Range: 0.4–1.6 seconds.
Default setting: 0.9.
Phone must be on-hook for at this time in sec. before the
ATA will tear down the current inbound call. It does not
apply to outbound calls. Range: 0–255 seconds. Default
setting: 0.
Delay after far end hangs up before reorder tone is
played. 0 = plays immediately, inf = never plays. Range:
0–255 seconds. Default setting: 5.
Expiration time in seconds of a call back activation.
Range: 0–65535 seconds. Default setting: 1800.
4
80