User Settings (User 1 And User 2) - Cisco SPA112 Administration Manual

Configuring Voice
Configuring Voice Settings
Cisco SPA100 Series Phone Adapters Administration Guide
Field
Symmetric RTP
FXS Port Polarity Configuration
Field
Idle Polarity
Caller Conn Polarity
Callee Conn Polarity

User Settings (User 1 and User 2)

Use the Voice > User 1 and Voice > User 2 pages to set the user preferences for
the calls through the PHONE1 and PHONE2 ports.
To open this page: Click Voice on the menu bar, and then click Line 1 or Line 2 in
the navigation tree.
Call Forward Settings
Field
Cfwd All Dest
Cfwd Busy Dest
Cfwd No Ans Dest
Description
Enable symmetric RTP operation. If enabled, the
SPA3102 sends RTP packets to the source address
and port of the last received valid inbound RTP
packet. If disabled (or before the first RTP packet
arrives) the SPA3102 sends RTP to the destination as
indicated in the inbound SDP. Default setting: no
Description
Polarity before a call is connected: Forward or
Reverse. Default setting: Forward
Polarity after an outbound call is connected: Forward
or Reverse. Default setting: Forward.
Polarity after an inbound call is connected: Forward or
Reverse. Default setting: Forward
Description
Forward number for Call Forward All Service. Default
setting: blank
Forward number for Call Forward Busy Service. Same as
Cfwd All Dest. Default setting: blank
Forward number for Call Forward No Answer Service.
Same as Cfwd All Dest. Default setting: blank
4
108