HP J6039C - JetDirect 200M Print Server User Manual page 180

Table 9.12 Error Messages (9 of 10)
Error Code and
Message
50 TFTP LOCAL
ERROR
51 TFTP RETRIES
EXCEEDED
52 BAD BOOTP/DHCP
REPLY
53 BAD BOOTP
TAG SIZE
54 BOOTP/RARP
IN PROGRESS
55 BOOTP/DHCP
IN PROGRESS
56 DHCP NAK
57 UNABLE TO
CONNECT DHCP SVR
58 POSTSCRIPT
MODE NOT
SELECTED
59 INCOMPLETE F/W -
MUST DOWNLOAD
5A TURN PRINTER
OFF / ON
ENWW
Description
The TFTP transfer of the configuration file from the host to
the HP Jetdirect print server failed with the local print server
encountering some form of inactivity timeout, or excessive
retransmissions situation.
The overall retrying of the TFTP transfer of the configuration
file from the host to the HP Jetdirect print server has
exceeded a retry limit.
An error was detected in the BOOTP or DHCP reply that the
HP Jetdirect print server received. The reply either had
insufficient data in the UDP datagram to contain the
minimum BOOTP/DHCP header of 236 bytes, had an
operation field that was not BOOTPREPLY(0X02), had a
header field that did not match the print servers hardware
address, or had a UDP source port that was not the
BOOTP/DHCP server port (67/udp).
The tagsize in a vendor-specific field in the BOOTP reply
is either 0, or greater than the remaining number of
unprocessed bytes in the vendor-specified area.
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/RARP.
The HP Jetdirect print server is currently in the process of
obtaining its basic IP configuration information through
BOOTP/DHCP, and has not detected any errors.
The HP Jetdirect print server received a negative
acknowledgement message from the DHCP server in
response to a configuration request.
The HP Jetdirect print server had received IP parameters
from a DHCP server, but communication with the DHCP
server has been lost. Check status of the DHCP server.
If an infinite lease was assigned, the print server will use the
IP address of the most recent DHCP server used, but
operation may be degraded until a DHCP server responds.
The printer does not support AppleTalk or AppleTalk
extensions.
Firmware download message. Currently downloading
firmware to the HP Jetdirect print server, or the download
did not complete properly.
Firmware download message. Download of firmware is
complete. Power cycle the HP Jetdirect print server.
HP Jetdirect Configuration Page 33