Configuration Page Messages - HP J6039C - JetDirect 200M Print Server User Manual

Configuration Page Messages

HP Jetdirect Configuration/General Information
Information in this section provides general HP Jetdirect print
server configuration as described in
see Table 9.12.
Table 9.1 HP Jetdirect Configuration (1 of 2)
Message
STATUS:
MODEL NUMBER:
HARDWARE
ADDRESS:
FIRMWARE VERSION:
PORT SELECT:
DATA RATE:
LAA
4 HP Jetdirect Configuration Page
Description
Current state of the HP Jetdirect print server.
I/O CARD READY: The HP Jetdirect print server has
successfully connected to the network and is awaiting data.
I/O CARD INITIALIZING: The HP Jetdirect print server is
initializing the network protocols. For more information, see
the status line for each protocol on the configuration page.
I/O CARD NOT READY: There is a problem with the print
server or its configuration.
An Error Code and Message is displayed if the print server
is not ready. For more information, see
The model number of the HP Jetdirect print server (for
example, J4169A)
The 12-digit hexadecimal network hardware (MAC) address
of the HP Jetdirect print server installed in the printer or
device. This address is assigned by the manufacturer.
The firmware revision number of the HP Jetdirect print
server currently installed in the printer. The format is
X.NN.NN, where X is a letter that depends on the
HP Jetdirect print server model.
(Ethernet only) Specifies the port on the HP Jetdirect print
server that has been detected for use:
NONE: The print server is not connected to the network.
RJ-45: The RJ-45 network port is connected.
Specifies the Token Ring data rate configured on the
HP Jetdirect print server: 4 Mbps or 16 Mbps.
The setting must match the data rate of the network.
The data rate is configured through a switch on the print
server. See your print server's hardware installation guide.
(Token Ring only) The Locally Administered Address (LAA)
identifies the user-specified node address of a Token Ring
print server. The default address is the print server's fixed
LAN hardware address.
Table 9.1. For error messages,
Table 9.12.
ENWW